On Sun, Dec 25, 2022 at 11:00:25PM +0100, Simon Brem wrote: > Hi there, > > I want to convert cc events from one controller of a device to > another controller of another device. I'm using alsa-midi. First I > want to do no conversion at all, just routing. I came this far: If I > monitor the source controller, I see cc-events with aseqdump. If I > monitor the output device, I see SysEx messages from Midish, and > "Active Sensing" while in idle mode or play mode. But no midi-events > from my source controller. I can also play a midi file to the output, > everything fine. > > This is what I'm doing in rmidish: > > dnew 0 "16:0" wo (write only, destination) > dnew 1 "129:0" ro (read only, source) > fnew myfilter (new filter) > fmap {ctl 1} {ctl 0} (route all cc messages from dev 1 to dev 0) > i (idle mode for connecting midi devices) > > With "aseqdump -l" I see everything is connected properly. But > there's just no data arriving at my destination device from the > source-device. Only SysEx from the Midish itself. What am I doing > wrong? > I tried exacly the same commands except for the device names and it works. Tested on OpenBSD, fwiw. Maybe midish isn't receiving the source events. If so, some "aconnect" magic may be needed on Linux. Could you run "debug mididev 1" in midish, retry and check that midish sees the incoming events?Received on Mon Dec 26 2022 - 09:57:41 CET
This archive was generated by hypermail 2.3.0 : Tue Dec 27 2022 - 01:30:01 CET